In this training program, Peter Orlando addresses both flash code and scan tool diagnostics giving you a 3-step diagnostic procedure for any ABS system. Peter shows you what you can do on ABS systems w/o a factory specific scanner. There are many great tech tips for saving time and avoiding costly mistakes, and in this training program that is just what you will learn.

Video Clip:

Peter uses various pieces of equipment, like a DVOM (digital volt ohm meter), logic probe, scanner, and scope to show you sensor testing, work on disabled systems and so on. You’ll see tips on flushing the system, easy bleeding tips, warnings on accidentally disabling ABS systems, code retrieval when there’s no scanner communication, and much more. There’s over an hours worth of coverage.

Examples of what you can expect to see in this course…

• Tips in “spongy pedals”
• Dealing with volatile code systems
• Brake light sequence grounding to ensure lamp circuit is in sync with the logic probe
• Inside and out of the ABS diagnostic connector
• Bad hydraulic units
• Hydraulic system service tips
  • Signal channels, hydraulic modulator assembly, ISO valve, master cylinder, accumulator

No Manual